Arkon Garmin nuvi Mount - Mini 1/2inch Dash/Console Mount with VHB Adhesive

The Arkon GN010VHB adhesive mount suits Garmin nuvi units built around the 17mm swivel ball fitting, covering the 40, 50, 200, 2013, 24x5 and 25x5 Series along with Garmin nuvi 1450, 1450T, 1490T, 1200, 1250, 1260T, 1300, 1350, 1350T, 1370T and 1390T. It also pairs with Garmin car mounting bracket holders that use the same 17mm swivel ball fitting. (Arkon stocks a number of these bracket holders matched to individual Garmin GPS units — refer to models GN-BKT50, GN-BKT40, GN-BKT25X5, GN-BKT24X5, GN-BKT2013 and GN-BKT1400.) Supplied here is the .5” Adhesive Mount with VHB adhesive on its own. The low-profile design mounts to virtually any flat surface, from a dashboard or centre console to a computer monitor or desktop, held in place by hard-wearing 3M VHB adhesive. (For the best hold, give the adhesive 24 hours to cure before fixing the base of the mounting pedestal to the centre of the disc.) WARNING: think carefully about placement before adhering the GN010VHB to a dashboard or any other flat surface. The 3M VHB adhesive used on this disc is intended as a PERMANENT bond, so fitting it may leave the disc permanently attached to the chosen surface. Removal may call for professional strength solvents or tools. Arkon accepts no responsibility for damage to your vehicle or any other surface resulting from installing this mounting disc. If you would prefer an adhesive mount with semi-permanent holding strength, take a look at Arkon Model GN010.