PPTAB106Arkon Portable Mobile Printer Car Truck Drill Base Mount for Zebra, Epson, Brother Printers

Features:

Printer holder that bolts firmly to a dash, table or worktop

Suited to printers used commercially, such as in a work truck or fleet vehicle

Accommodates almost any printer measuring 7" to 18.4"

Four support legs included to suit different printer sizes while leaving buttons and ports reachable

Full 360° swivel so the printer can sit vertically or horizontally

8" mounting arm with tightening knobs for multi-angle printer positioning

4-hole AMPS mount included for secure fixing options

A further 10 support legs supplied for holding tablets from 7" to 18.4"

Hard-Wearing Slim-Grip® Printer and Tablet Holder

Made from tough composite materials, the slim-grip holder keeps printers and tablets from 7" to 18.4" firmly in place. A spring-loaded action, grippy pads and a cushioned backing mean your printer or tablet goes in and comes out with one hand — just push down on the lower legs. The mount rotates a full 360° for vertical or horizontal printer positioning.

Several Support Leg Combinations

The Slim-Grip® Holder comes with four support legs for a range of printer sizes, plus ten legs in assorted lengths to suit different tablets. Fit them at the top and bottom of the holder to build a support layout that matches your device and keeps side buttons and ports clear. With tablets, run two short legs up top and two long legs below for bigger units such as the iPad Pro, or use all four short legs for compact tablets and all four long legs for larger ones.

Strong Multi-Angle Arm

A sturdy 8" multi-angle arm carries three adjustment knobs spaced at 2.5" intervals along its length for completely flexible printer positioning. Two additional 180° pivot points at the top and bottom of the mount refine the angle further, giving the operator total say over where the printer sits.

4-Hole AMPS Mounting

The 4-hole AMPS pattern is a rectangular arrangement of four holes spaced 30.17mm by 38.05mm (measured centre to centre). Machined from heavy-duty aluminium, the 4-hole drill base mount provides a rock-solid fixing for car and truck dashes, workshops or retail counters.

Specifications:

Design: Heavy-duty printer and tablet holder with 8" multi-angle arm and 4-hole AMPS mount

Model: PPTAB106

Printer and Tablet Size: 7" to 18.4"

Materials: Reinforced composite and heavy-duty aluminium

Mount Type: 4-Hole AMPS