RMVHB2TArkon Robust Car Dash or Flat Surface VHB Adhesive Mount

The RMVHB2T is a 70mm flexible adhesive base built around extra-strength 3M VHB adhesive, and it works with Arkon and other third-party Dual-T phone and tablet holders (sold separately). Supplied in the package: the extra-strength adhesive mount base, a Robust Series pedestal and a Dual T-Tab head. The underside of the mount measures 70mm (2.75 inches) and is split into 8 “petals” that flex independently, letting the disk conform to slightly curved dashboards or other surfaces. Fitting is straightforward — peel the red plastic backing from the rear of the 3M VHB mounting disk, then position it on a surface you have already cleaned and press down firmly. For the strongest result, allow 24 hours for the adhesive to cure before fastening the base of the mounting pedestal to the centre of the disk. WARNING: use care and good judgement when deciding where to adhere the RMVHB2T on your car dashboard or any other surface. This disk uses 3M VHB adhesive, which is engineered as a PERMANENT solution, so the disk may end up permanently bonded to the surface you choose. Professional strength solvents or tools may be needed to remove the adhesive. Arkon is not responsible for any damage caused to your vehicle or other surface as a result of installing this mounting disk.